AOJN Deburring tool with 10 blades in three types, 6 needle files and flush cutter

The AOJN deburring set listing, bullet by bullet

Five bullets: a head that turns through 360° for straight edges, curves and small holes; ten blades in HRC 63–66 high-speed steel, stated to keep over HRC 50 at 600 °C, in three types by steel, angle and use; six needle files in GCr15 bearing steel at 61–65 HRC, in flat, smooth, square, triangular, round and half-round shapes; a 65Mn micro flush cutter with a 21° handle and 6 mm jaw; and the set of deburrer, blades, files and cutter for prints, metal, resin and plastic.

AOJN’s blade table

BS1010, BS1018, BK3010. Each blade type comes with its steel, its edge angle and its hardness, and a use: general materials, stainless steel, or small holes around 1.5 mm. That is enough to reorder the right one.

AOJN’s flush cutter

The cutter is sized in the fourth bullet: a 6 mm jaw, copper wire from 0 to 2 mm, and flush cuts up to 1.3 mm. The same bullet names plastic edges and cable ties as well as wire.

Availability

At the last look-up, the German, French, Italian and Spanish Amazon stores were asking 13 € to 17 €.

The American and British Amazon stores returned no entry, so the buy button there opens a search rather than a missing page.

Every figure here is Keepa’s reading on the date this page was last updated. Stock and prices can change at any time.