SIQUK MK8 brass nozzles, 22 pieces, 0.2 to 1.0 mm

The SIQUK nozzle set listing, bullet by bullet

Five bullets: 22 MK8 nozzles in seven sizes, ten of them 0.4 mm; a 1.75 mm input, outputs from 0.2 to 1.0 mm and an M6 thread; compatibility with MakerBot, CR-10, RepRap and Prusa i3 printers and 1.75 mm PLA and ABS printers; brass construction, fitted by the M6 thread; and a warning to keep the small parts away from children.

Ten SIQUK nozzles of one size

Ten of twenty-two are 0.4 mm. The other six sizes come as pairs. The set is weighted toward spares of a single size, with finer and coarser nozzles alongside. The listing text does not say the nozzles are marked; the product photograph shows each one engraved with its size.

SIQUK brass and abrasive filaments

The listing names brass and PLA and ABS, and says nothing about abrasion. The two nozzle listings here that name carbon fibre are the MICREEN hardened steel set and the DUROZZLE ruby nozzle.

Availability

At the last look-up, the German and French Amazon stores were asking 7 € to 8 €.

It is sold in the British Amazon store as well, in its own currency, which the euro figures above leave out on purpose.

Asking prices on the Italian and Spanish Amazon stores ran past 1.6× the lowest country’s. A gap that size points to goods shipped in from abroad rather than a local seller, so those offers are left out of the figures above.

The American Amazon catalogue lists the product, yet no seller was offering it.

Every figure here is Keepa’s reading on the date this page was last updated. Stock and prices can change at any time.