UniTak3D FEP film 140 × 200 mm, 2 sheets

The UniTak3D FEP listing, bullet by bullet

Five bullets: over 95 % light transmission for stable UV exposure; good peeling performance; resistance to 204 °C and chemicals, a non-stick surface and a claim of more than thirty thousand releases; compatibility with the ELEGOO Mars, Anycubic Photon, Wanhao UV and other 5.5-inch printers; and a size of 140 × 200 mm and 0.15 mm.

A sheet for small, older printers

140 × 200 mm fits 5.5-inch vats. The printers named are earlier models; newer, larger printers need bigger sheets, like the Antinsky and ELEGOO films here.

Thirty thousand releases

The third bullet claims more than thirty thousand release cycles. No layer height, resin or print conditions are attached, so the figure indicates durability without predicting it.

Availability

At the last look-up, the German, French, Italian and Spanish Amazon stores were asking 10 € to 13 €.

The American and British Amazon catalogues list the product, yet no seller was offering it.

Every figure here is Keepa’s reading on the date this page was last updated. Stock and prices can change at any time.